the coating of cell phone jammer will be difficult

And the coating of cell phone jammer will be difficult to be damaged
Any kind of changes in environmental parameters of the environmental factors influencing factors listed below will result in approximately 1um error: (a) Air temperature: 1 ℃ b. Air pressure: 0.3kPa c Relative Humidity: 30% in particular, vibration impact on the measurement is very large, vibration may cause the dispersion of the measured data significantly affect the repeatability of measurements. May even make the measurements can not be down. Reduction and elimination a. Try to make measurements in a heated workshop, in order to maintain a relatively stable environment. environmental parameters deviate from the standard conditions, you can use the EC10 environmental compensation unit to automatically compensate for temperature, pressure, humidity can make the above the error is reduced to ± 1 .1 um. It is compared with other kinds of phone jammer .
Try to turn off the lights, workshop lights on the machine in order to reduce the heat source. (d) in the summer, in order to reduce the laser heating, the available fans to heat and cool to extend the time of the use of lasers. (e) in the measurement should be to avoid the generation of the workshop a variety of vibration, such as machine tools, driving. Can be used: If necessary, measurement of work or in the evening relatively quiet environment. ? should mirror and interference environment lasers installed as close as possible to the location of the machine tool / skateboard position and bed position. Use the shortest possible pole mounting accessories to the fixed optical components. Magnetic table seat should be directed to absorption in the surface of the machine bed or turret. The green laser beam light of phone jammer is not that stable.Selected in the step the step width, contour elevation difference. The establishment of the triangular network model. Open the model of point cloud data: in the point cloud data following the establishment of the plane of the front of the plane : i click on the right side of the edit bar icon in the lower right the side of the edit box the plane set and attribute charts: ii set cemara mode to the orthogonal mode: At this point, the page will appear the picture of the grid: iii click on the plane to create a button, use the drop-down box option From 2 points , a dialog box will pop up dialog box will appear in the plane name and settings.