What follows are FAQ when a cell phone jammer is used to control PPT documents

What follows are FAQ when a cell phone jammer is used to control PPT documents.  can not be used in rapid wire machines. Slow walk the wire machine you can use a variety of copper wire, wire, special alloy wire, and coating (such as zinc, etc.) on the electrode wire. The electrode wire diameter d should be based on the kerf width of the workpiece, the workpiece thickness, corner size and cutting speed requirements selected. Figure 6.26, the electrode wire diameter d and the relationship of corner radius foot for d ≤ 2 (R-δ).
   Requirements on green cell phone jammer are higher than red ones. the choice of pulse power of the pulse waveform, a rectangular pulse (divided into 4 files) and packet pulse two waveforms. Require particularly high when the surface roughness should be selected packet pulse, to ensure that the electrode wire when finishing a smaller loss. Rectangular pulse can be used to obtain a higher cutting speed. (2) the choice of the pulse width of the pulse width is wider the single pulse energy, the greater the discharge gap to increase the efficiency of cutting, processing more stable, but will reduce the surface roughness of the processed.
Figure 6.20a, c shown in the cut line is wrong, if this line processing, the first paragraph of the cutting will be the main joints severed, the remaining material to less connected with the clamping part, workpiece stiffness lower, easy to produce deformation. High temperature may even burn the laser diode of a cell phone jammer.  Therefore, under normal circumstances, it is best to split the line of the workpiece with its gripping part arranged at the end of the cutting line. (2) to avoid inward cut from the workpiece lateral face, while the use of prefabricated from the workpiece to wear a wire hole from the hole machining, as shown in Figure 6.20c, d as shown.
 Table 6.8 commonly used electrode wire material and characteristics of materials, pure copper brass diameter / mm O.1 ~ 0.25 O.1 ~ O.30 characteristics suitable for cutting speed do not ask or finishing, silk is not easy to curl. low tensile strength and easily broken wires suitable for high speed machining, the machined surface erosion crumbs attached, surface roughness and flatness of the machined surface are better suited for high-speed, high precision and the desired surface roughness processing and automatic wear wire,
 R16 arc processing of the processing of straight-line processing line processing slash processing under R10 arc processing slash processing straight-line processing of R16 left arcN0011 G01 X-7; N0012 X6 Y-8; N0013 G02 X12 Y0 I6 J-8; N0014 G01 G40 X-6 Y-8; N0015 M02;  This principle of ultraviolet cell phone jammer is the same as the disinfection effect of UV lamp.  processing line processing slash processing R10 arc back to the starting point, to cancel the wire diameter Example 6.4 Figure 6.17 shown blanking die in the end of the compensation program, to take the electrode wire diameter was 0.12 mm, unilateral discharge gap is 0.01 mm.